Sunday, April 2, 2017

Hannah Revelle- Week 11 Laser engraving



Concept 

For my Laser Engraving project I want to make a hand mirror for when I travel. I have a tattoo of a sun so I am following this design to start than I played around until I found a appealing design. 

Technique

I made 3 curves for the rays of the sun than used the rotate command with copy to yes to make a complete circle. I than joined the outer layer. The inner ray is just one curve I made and than the waffle design that will be engraved on my piece is using the command Hatch. I have an inner cut for my mirror and I am printing a blank back to attach the mirror to. 


No comments:

Post a Comment