Makercase Lamp
|
Keyshot 1 |
Concept:
|
Reference 1 |
|
Reference 2 |
My makercase lamp was inspired by gothic architecture. More specifically the straight lines, the sharp objects and the engravings within the architecture.
Process: |
Laser cut curves |
|
Ghosted and Make2D |
Firstly I started by using the makercase site to make a box with with 5 fingers and no top. I exported that into rhino and began using the provided voronoi definition on two sides of the box. Next I used the provided lines definition on the two other sides that have the cross on it. I then added the cross and two logos that I had made back in high school to the front and back. I boolean differenced the logos and cross out of the box. Lastly I chamfered the bottom of the box to make it look more sleek.
Materials:
|
Keyshot 2 |
|
Keyshot 3 |
I got the wood laser cut and assembled using Loctite. This lamp was partially made with the idea to give it to my mom so I added white parchment paper to the insides of the lamp to help the light give off a modern, warm tone. I also decided not to paint it because I like the burn marks from the laser.
No comments:
Post a Comment