Blake Philley: Week 7 Serial Slicing

I've made a vase with some indentations in the center. I had to set up the inner parts as blue rings, because I believe that if I leave them as magenta the laser cutter con't cut them properly. Other than that the project wasn't too difficult. I put a simple gray material on the vase in keyshot so it's much easier to see all the contours.

I modeled this object in maya since it required inner extrusions to be set up along a curved surface, and I wanted to preserve that curve. This was also made using using extrusions and by manipulating vertices.

I took a bit of inspiration from this vase:

And David Norkiewicz's serial sliced tower.